Sat Slate
Order the pre-configured Heltec Wireless Paper display.
Device Setup
Push your WiFi and location settings directly to the Sat Slate via USB.
👁️
Firmware Update
Update your Sat Slate to v0.2.0 via USB.
Meshtastic Network
Your Sat Slate hardware is fully compatible with the open-source Meshtastic communication network. You can overwrite your firmware to use it for off-grid messaging.
⚠️ CRITICAL WARNING
You MUST attach the included LoRa antenna BEFORE flashing Meshtastic.
Meshtastic activates the radio transmitter immediately upon booting. Transmitting without an antenna attached will cause the radio signals to bounce back into the board, permanently destroying the LoRa chip.
1. Flash Meshtastic
Click below to leave this site and use the official web flasher. Select Heltec Wireless Paper as your target device.
2. Get the Companion App
To send and receive messages, pair your flashed device to your phone via Bluetooth using the official app.
Want to switch back?
No problem. You can return to this website at any time, click the Firmware tab at the top, and reinstall the Sat Slate display software in one click.
FAQ
How do I flash?
Connect via USB-C and click "Install" on the Firmware page. If the device isn't found, hold the BOOT button while plugging it in.
Battery Life?
Depending on your refresh frequency, the Sat Slate can last weeks on a single charge.
About Atlas
Atlas designs minimalist hardware for the modern home. We bridge the gap between digital data and physical space through low-power E-ink technology. The Sat Slate is our flagship display for persistent, low-noise information.